Wednesday, December 14, 2011
Original Dog Paw Print Wrapping Paper
Here is a great idea for original wrapping paper and you will not have the mess of letting your dog walk all over wrapping paper with painted paws.
Make a paw print stamp!
What you will need:
1. Clay (regular modeling clay, modeling compound, or Play-Doh)
2. Petroleum jelly
3. Hot glue gun & glue sticks
4. Several small blocks of wood, a little larger than you do's paw
6. Roll of plain paper
7. Nontoxic, washable poster paint
8. Paper plate
9. Paper towels
How to make it:
1. Work the clay with your hands until it is soft and pliable, then form several disks of clay, about 1/4 inch thick, a little larger in diameter than your dog's paw. The disks should not be very thick, so the paw print will be as flat as possible, to make a good stamp.
2. Press your dog's paw gently into each disk. The paw print should be shallow, while still being clearly a paw print.
3. Coat the inside of the paw print and the surrounding area of the clay with a think layer of petroleum jelly.
4. Plug in the hot glue gun. Fill the paw prints with hot glue, filling in each indentation, then covering the whole paw print and about 1/4 inch surrounding it with a thick layer of glue.
5. Gently place a wooden block on top of each paw print. This will be the back of your stamp. Allow the glue to dry for about five to ten minutes.
6. Gently remove the blocks and glue prints from the clay mold. If some of the clay has melted or stuck to the mold, just wipe it off.
7. Sand the glue to be somewhat flat, or rub it against concrete, such as a front step or your driveway. This will make for a better stamp.
8. Spread paint thinly on a paper plate. Dip your stamps in. Make a few sample prints on the plate to find which stamps make the best prints. Use the best ones for your wrapping paper project.
Stamp away on your wrapping paper or use the stamp to "sign" cards, seal envelops, or letterhead.
Be sure to treat your dog for helping you with this art project.